Lascaux Plate-backing resist is water-soluble, ready to use, non-toxic and suitable for use on copper, brass, zinc, steel and aluminium. This red coloured resist is highly acid-resistant, durable and scratch-resistant. It may be used on unbitten or previously etched (e.g. aquatint, deep open bite) and is compatible with the other Lascaux resists and photopolymer resists such as Photec. The resist may also be used to create a variety of effects on collagraph plates (see Collagraph data sheet for details). Directions Plates should be prepared, grained, degreased and dried before the Plate-backing resist is applied by brush (follow the detailed information provided in the technical sheet for Lascaux Hard resist). After the first application of resist has been dried a second coat may be applied. Drying the resist: The plate can be laid flat to dry naturally or dried with a warm air fan in a horizontal drying cabinet. The resist becomes touch dry quickly and when it is fully dry the plate may be etched. Etching: Plates should etched following the detailed information provided in the technical sheet for Lascaux Hard resist. Resist removal: The resist is water-soluble and can be cleaned from brushes, tools, palettes, plates and surfaces with warm soapy water before it dries. Dried resist can be removed with Lascaux Remover (follow the information provided in the technical sheet for Lascaux Hard resist or Lascaux Remover).